HI-Temp Wire, ST-950
Scrap Glass / Odd Cuts
1.Using MR-97, spray your mold with 3 coats. *Make sure to use MR-97 in a well-ventilated area and wear safety gear.
2. Place the flat piece next to mold to create a block. Wrap the Hi-Temp wire around the mold to secure the pieces. Use pliers to tighten the wire.
3. Place glass laying face down.
4. Move into kiln and use suggested firing schedule.
5. Use hot brick for extra support if needed.
Suggested firing schedule (3 lbs glass):
Slumpy's Bargain Basement
Check out the lowest prices within Slumpy's Bargain Basement. Get great deals on discontinued items! Numbers are limited and sale items are subject to change at any time. Get them before they are gone!